Plunge Router Issues

I have a DeWalt DW618 router (router motor unit). This router comes with both a fixed based (DW6184) and also a plunge base (DW6182). And the router motor is a separate unit, which you then attach to either the fixed base or the plunge base.
Continue reading “Plunge Router Issues”

Advertisements

A Good Method for Trimming End Grain

This is going to be a short post, but some useful information (I think anyway).

Now I have heard of using water on end grain prior to planing with a handplane. However, what with being concerned with tear-out, I shy away from using a handplane on end grain.

So instead of using a handplane, I use a random orbital sander (ROS). It tends to be slow going, but no tear-out worries. Then, it dawned on me. Why not wet the end grain with water? And then go to town on it with my ROS. I wonder if that would work? Well, it does.

I would guesstimate that it cut my sanding time in half. Plus, surely it is cutting down on the amount of sawdust going airborne.

Why in the world did I not think of this before?

Give it a try.

Request
If you enjoyed this post, I would be very grateful if you would share it by email with a friend, or on Google+, and/or Facebook. And while I am being needy, would you give me a “Like” on my Facebook page (Woodworking with AJO)? You can click on the link shown below for my Facebook page. Thanks a bunch.

Woodworking with AJO

Take Care
AL

John 3:16

Making Clamping Squares From 3/4” OSB

Looking for an inexpensive set of clamping squares? Same here, and what follows is what I came up with.

Topics Covered
1. Build Sequence
2. Finish
3. Clamping Square Usage
4. In Closing
5. Request

1. Build Sequence
Using your table saw cut four pieces of 3/4” OSB to the following dimensions: 3/4” x 3” x 12”. The four OSB boards shown in Photo 1 will not be the final dimensions, just the dimensions you will start with.

Continue reading “Making Clamping Squares From 3/4” OSB”

Grizzly 17” Band Saw (G0513ANV) Setup

he pTopics Covered
1. Purchase
2. Setup
……Step 1—Guide post handwheel
……Step 2—Positive stop bolt
……Step 3—Quick-release tension lever
……Step 4—Move blade guides away from blade
……Step 5—Remove the saw blade
……Step 6—Install band saw table
……Step 7—Reinstall the blade
……Step 8—Check & adjust tracking of the blade
……Step 9—Square tabletop to blade
……Step 10—Dust collection
……Step 11—Electrical power plug
……Step 12—Test run
……Step 13—Blade tensioning
……Step 14—Adjust distance between blade guides and blade gullets
……Step 15—Adjust distance between blade guides and blade
……Step 16—Adjust distance between back of blade & support bearings
……Step 17—Align the table to the blade & fence
……Step 18—Calibrate the miter gauge relative to the blade
3. Resawing Video
4. Summary
5. Request

1. Purchase
Knocking $20 off the sale price and free shipping sounded good to me. So I ordered the Grizzly Model No. G0513ANV band saw. And with 17” wheels and a 2-hp motor, I was looking forward to getting and powering this beast up.

Regarding cost, I paid $875 for this saw (back in Feb 2015).

Here are the stats for the Grizzly Model G0513ANV band saw.

Continue reading “Grizzly 17” Band Saw (G0513ANV) Setup”